Stackables use 120/240, 30 amp receptacle for the dryer and 120V receptacle for the washer. Finally, connect the washer and dryer to the correct outlets, and now you should be good to go.Įlectric stacked laundry centers run off a 120/240, 30 amp receptacle. This Washer & Dryer Stacking Kit can be used in tight spaces to place the dryer on top of the washing machine, freeing up additional room. Carefully lower the tumble dryer into the bracket so. Make sure the washing machine is level by adjusting its legs. Remove the feet of the tumble dryer so that it will slot into the bracket and lock in place within the lip of the bracket. Follow the instructions on the stacking kit to connect the units together. Make sure both your washer and dryer are unplugged before stacking. Or, you can mount your dryer to the wall. ![]() You should only use rubber mats with a vented dryer. The dryer and washing machine must be the same width or the washer must be larger than the dryer. Included with a Blomberg dryer purchase, it works on units of differing sizes. Once the units are in and you’ve prepped the area, place the washer in first and then the dryer. To stack a washer and dryer without a kit, place an Enviro Rubber APL600 rubber mat on top of the washer to minimize movement. Get the most out of even a two-foot nook with the Universal Stacking Kit. Once completed, tape off the area where the washer dryer will go, allotting 2-inches of space from the walls. However, if the space doesn’t have existing outlets, vents, and water access, someone will need to install these before proceeding. If there is an old washer dryer, remove them and sweep the area before bringing the new one into the space. For T1 White Edition tumble dryers Fits all Miele Washing Machines. Measure any doorways and hallways that you’ll move the stackable through to ensure there is enough room. Washer-dryer stacking kit For space-saving and safe installation of a washer-dryer stack. Now it is time to install the stackable washer dryer, but first, there is some prep to do. ![]() You have all the measurements and have a space that already has the vents and hookups necessary.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |